Example 1:
Two pairs of 8 Ohm ceiling speakers are to be used with two volume controls, all driven by a single amplifier rated for 8 Ohm minimum safe operating load impedance.
1)Refer to “CHART A”, 8 Ohm Minimum Amplifier.
2)In the first column, find “8 Ohms”.
3)Follow the row to the right until you find “2 PAIR”.
4)Follow the column up to the very top row and find that the jumper setting should be set to “x2” for both volume controls.
Installation Tip – Setting the Volume
1)Set your receiver and/or amplifier to the lowest possible volume setting.
2)Turn all the volume controls to maximum volume (up position for slider volume controls, full clockwise position for rotary volume controls).
3)Turn up the receiver and/or amplifier volume setting until you reach the maximum listening level desired.
4)Finally, lower the volume control level. Volume setting is now complete.
Changing the Face Plate
1) Gently press the tabs up on all four corners.
2) Lift the face plate off the metal frame and remove.
3) Replace with the correct color face plate.
