OS/2 TCP/IP
6.
7.
c)One at a time press the soft buttons on the Touch Screen for each octet of the broadcast address and enter the numbers from the keypad. When finished press the Save button on the touch screen and you will be returned to the TCP/IP Settings Screen.
Set the Host Name.
a)Press the Host Name and Address button.
b)One at a time press the soft buttons on the Touch Screen for each Octet of the IP address and enter the numbers from the keypad.
c)Press the Host Name button.
d)When the soft keypad appears, type the host name EXACTLY as you want it to appear with proper case. When finished press the Save button to record the changes and exit to the TCP/IP Settings screen.
Set the Subnet Mask and Gateway
a)Press the Subnet and Gateway button.
b)One at a time press the soft buttons on the Touch Screen for each octet of the Subnet Mask and enter the numbers from the keypad. Repeat this process for the IP Gateway address. When finished press Save to record the changes and exit to the TCP/IP Settings screen.
c)Press the TCP/IP - LP button. At the next screen press Enable then press Save.
d)Press the Exit Tools button.
8.Wait a MINIMUM of 7 minutes for the printer to reset.
9.From the documentation package supplied with your printer, retrieve the CentreWare Network Services
Go to a workstation and...
1. Create a new printer and load print drivers from the
2. Create a printer share and its access permissions (sharing and connecting).
3. Start LPRPORTD/LPRMON, ping printer, open EPM and send a print job to the printer.
4. Check your test job for quality and use the problem solving section of the Document Centre 240/255/265 Reference Guide for resolving print defects.
5. If your print job does not print, refer to the troubleshooting section in the document entitled Network Installation and Troubleshooting Guide to correct the problem.
6. Repeat this Go to a workstation and...
procedure at each workstation that will print to this printer.
Page 2
