CONNECTIONS

●Before making any connections, switch OFF the power to the unit and the amplifier or other component.

●Connections should be made to the correct input terminals of the amplifier or other component.

●If the placement of this unit causes noise to other equipment, such as a tuner, separate them from each other.

CDC-501

LINE OUT

L

R

To AC outlet

CDC-901

LINE OUT

DIGITAL

 

AUDIO

 

OUT

 

OPTICAL

L

R

To AC outlet

➋

Connection cord

➊ (included)

Optical fiber cable (not included)

Amplifier

OPTICAL

CD

DIGITAL IN

Choose one of the ways listed below to connect this unit to your amplifier.

When the LINE OUT (analog) terminals of this unit are used ( ➊ )

●Be sure that the left (“L”) and right (“R”) LINE OUT terminals are connected to the corresponding (left and right) terminals of the amplifier or other component.

●Connect the “LINE OUT” terminals to the “CD” (or “AUX”) terminals of the amplifier. If the amplifier does not have such terminals, use the “TAPE PB” terminals. For additional details concerning these connections, refer to the operation instructions for the amplifier being used.

CDC-901 only

●Adjust the level of signals output into an amplifier, etc. by using the OUTPUT LEVEL buttons.

CDC-901 only

When the DIGITAL AUDIO OUT (OPTICAL) terminal of this unit is used ( ➋ )

●Before using this terminal, remove the terminal’s cover by pulling it.

●Make the connection from this terminal to the optical input terminal of an amplifier by using a commercially available optical fiber cable.

*Use an optical fiber cable that conforms to EIAJ standards. Other cables might not function correctly.

●Be sure to attach the terminal’s cover when this terminal is not being used, in order to protect the terminal from dust.

●Set the level of signals output into an amplifier to max. by using the OUTPUT LEVEL buttons.

●This terminal can also be connected to the optical input terminal of a digital audio tape deck (DAT) etc. to record CD onto tape directly.

5