Rear panel
1CD input jacks
Connect a CD player.
See page 6 for connection information.
2PHONO jacks and GND terminal
The PHONO jacks are designed to connect a turntable with an MM cartridge.
See page 6 for connection information.
3Audio input/output jacks
Connect external components, such as a tuner, etc. See page 6 for connection information.
4VOLTAGE SELECTOR
(Asia and General models only)
The VOLTAGE SELECTOR must be set to your local main voltage before plugging the supplied power cable into the wall outlet.
See page 8 for details.
5AC IN
Use to plug in the supplied power cable.
See page 8 for connection information.
6SPEAKERS terminals
Connect one or two speaker sets.
See page 6 for connection information.
7IMPEDANCE SELECTOR switch
See IMPEDANCE SELECTOR switch on this page.
8AC OUTLET(S)
Use to supply power to your other audio/video components.
See page 8 for details.
CONTROLS AND FUNCTIONS
INTRODUCTION
(Asia and General models)
■IMPEDANCE SELECTOR switch
CAUTION
Do not change the IMPEDANCE SELECTOR switch while the power of this unit is turned on, as doing so may damage the unit.
If the unit fails to turn on, the IMPEDANCE SELECTOR switch may not be fully slid to either position. If this is the case, slide the switch all the way to either position when this unit’s power supply is completely cut off.
Select the switch position (LOW or HIGH) according to the impedance of the speakers in your system.
Switch
Impedance level
position
•If you use one set (A or B), the impedance of the speaker must be 6 Ω or higher.
•If you use two sets (A and B) simultaneously, the impedance of each speaker must be 12 Ω
HIGH or higher. (Except for U.S.A and Canada models)
•If you make
•If you use one set (A or B), the impedance of the speaker must be 4 Ω or higher.
•If you use two sets (A and B) simultaneously,
the impedance of each speaker must be 8 Ω or
LOW higher.
•If you make
English