STANDBY mode

(U.K. and Europe models only)

While the power is on, pressing the POWER key on the remote control transmitter switches the unit to the STANDBY mode. (In this mode, the indicator is half illuminated.)

Note

The POWER switch on the front panel of this unit should be turned off when left unused for a long period of time.

POWER

POWER

POWER on mode

STANDBY mode

NOTES ABOUT THE REMOTE CONTROL TRANSMITTER

Battery installation
Remote control transmitter operation range
AX-590AX-490

2

1

Remote control sensor

3

Battery replacement

If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones.

Notes

●Use only AA, R6, UM-3 batteries for replacement.

●Be sure the polarities are correct. (See the illustration inside the battery compartment.)

●Remove the batteries if the remote control transmitter will not be used for an extended period of time.

●If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

Within approximately 6 m (19.7 feet)

30

 

°

°

30

 

 

Notes

●There should be no large obstacles between the remote control transmitter and the main unit.

●If the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp etc.), it might cause the remote control transmitter not to work correctly. In this case, reposition the main unit to avoid

direct lighting.

12