■Manual tape programming

With this function, you can program tracks from one or more discs in any order to be recorded onto tape.

1 Stop the unit.

STOP

 

2 If you will select tracks from a disc (or discs) other than the disc on the Disc 1 tray, make this unit display the total recorded time of each disc to be used by pressing the DISC SKIP button in turn.

*This unit will read the contents of a disc by this operation. If there is a disc to which this operation is omitted, tracks on the disc cannot be programmed.

3 Follow step 4 on page 18.

4 PROG

PROG

5 If necessary, select a desired disc by pressing the DISC SKIP button.
6 Select a

8

desired track.

 

7 Repeat steps 5 and 6 to program more tracks for side A of the tape. You can select the same track again.

*If “ERROR” appears in the display, the track number just selected cannot be programmed because there is no enough time remaining on side A of the tape.

8 When you finish the programming for side A, program the pause mode by pressing the TAPE button.

TAPE

*“PAUSE” lights up in the display, and after then you can begin programming for side B.

 

SYNCHRO

 

DIMMER

TEXT/

OPEN/

 

8

 

TIME

CLOSE

4, 10

1

2

3

CLEAR

INDEX

 

 

 

TAPE

PROG

 

6

4

5

6

 

+I0

 

7

8

9

 

0

 

2, 5

DISC SCAN MODE REPEAT RANDOM

12

DISC SKIP

 

SEARCH

– OUTPUT LEVEL +

SKIP

 

1

 

STOP

PAUSE

PLAY

 

11, 12

 

 

 

 

 

9 Repeat steps 5 and 6 to program more tracks for side B of the tape.You can select the same track again.

*If “ERROR” appears in the display, the track number just selected cannot be programmed because there is no enough time remaining on side B of the tape.

10 The peak level searching function of this unit is useful for adjusting recording level on the tape deck. For peak level searching, when the programming for side B is finished, press the PROG button and then press the PEAK button on the front panel. (Refer to page 21.)

11 Start recording on the tape deck and press the PLAY button on this unit’s remote control transmitter at the same time.

12 The unit will pause at the end of side A of the tape. Turn the tape over to side B. Resume recording and, at the same time, press the PLAY or PAUSE button on this unit’s remote control transmitter.

Notes

●In steps 7 and 9, even if “ERROR” appears in the display, you can program another track of which time is shorter than the remaining time on the side of the tape. At this time, if any other track number lights up in the display, you can program it.

●CD synchronized recording function can be used if your tape deck is compatible with it.

In this case, in steps 11 and 12, press the SYNCHRO button and then press the PLAY button on this unit’s remote control transmitter. Recording automatically begins.

(For details, refer to page 17.)Notes on tape programming●To check, cancel or correct program data, refer to page 15.●The maximum number of tracks that can be programmed is40.If, however, the PAUSE mode is inserted, it is counted as one track.

●This function can be used to program up to track number 20. If the disc has more than 20 tracks, tracks with track number

21and higher cannot be programmed.

English

19