Notes
●You can set as many as 20 programs at one time.●If you will make programming with the DISC 1 tray empty, be sure to press a DISC SKIP button before starting programming.
●The total time of the programed tracks will not be displayed, if tracks are selected from more than one disc.
●The total time of the programmed tracks will not be displayed, if a track number higher than 20 is programmed.
●If, during programming, the TIME display
●The SKIP (
and 
) button can be used during playing, but only within the range of the programmed tracks.
●The SEARCH ( 
and 
) button can be used during playing to search through all tracks, including unprogrammed tracks.
ENGLISH
To stop program play
●Press the STOP button. The first track number programmed will be displayed.●To resume play, press the PLAY button. Play will begin from the beginning of the program.
To cancel a programmed setting
There are several methods, as described below.●Press the CLEAR button while the unit is stopped.●Press the STOP button while the unit is stopped.●Open the disc tray.●Switch off the power.To check programmed data
1.If the unit is in the play mode, press the STOP button.2.Press the PROG button.3.Each time the SKIP 
button is pressed, the track numbers and sequential order of the programmed tracks can be checked one after another. The display of the track number can be returned (sequentially in reverse order) by
button.To correct programmed data
1.Follow the procedure described in “To check programmed data”.2.Display the track number to be corrected by pressing the SKIP button.3.Press the SEARCH button several times until the track number to replace the previous one appears, and then press the SKIP button once. The previously programmed track is cleared from the memory and the new one is programmed.
4.After the correction has been completed, press the PROG button or PLAY button once again.
11