CONTROLS AND FUNCTIONS
■Preparing the remote control
The remote control comes with the battery already installed. Before using the remote control for the very first time, pull out the insulation sheet, as shown.
Insulation sheet
y
Remove the transparent sheet before using the remote control.
■Using the remote control
Use the remote control within 6 m (20 feet) of the component you want to control and point it toward its remote control sensor (see page 3).
VOLUME
STANDBY ON | INPUT |
| PHONES |
Within 6 m (20 feet)
30˚30˚
FM
Notes
•Be careful not to spill liquid on the remote control.
•Be careful not to drop the remote control.
•Do not leave the remote control in the following places:
–hot or humid places, such as near a heater or in a bathroom
–extremely cold places
–dusty places
■Replacing the battery in the remote control
Change the battery when the operation range of the remote control decreases.
Use a straight pin to | Replace the battery | Close the cover. |
remove the cover. | with a new CR2025 battery. |
|
Notes
•Insert the battery according to the polarity markings (+ and
•If the battery runs out, immediately remove it from the remote control to prevent an explosion or acid leak.
•If the battery starts leaking, dispose of it immediately. Be careful not to let the leaking battery acid touch your skin or clothing.
•Before inserting a new battery, wipe the compartment clean.
•Dispose of batteries according to your regional regulations.