165
CVP-202
This message appears when you try to perform an operation (such as selection of a style
or Music Database setup) that cannot be performed during playback.
➾Stop song playback, or exit the Song Play mode, then perform the operation again.
This message appears when you try to perform an operation (such as copying or deletion
of song data) that cannot be performed in the Song Record mode.
➾Stop recording, or exit the Song Record mode, then perform the operation again.
A button that does not have a function in the current mode has been pressed.
This prompt appears when you press the [DIRECT ACCESS] button (page 21).
➾Press the panel button that corresponds to the settings you want to display. (Be
sure to press the second button while this message is showing.)
This message appears if you press [DIRECT ACCESS] followed by a panel button that
does not correspond to a Direct Access display. (See page 21.)
➾Press [DIRECT ACCESS] again, then press a panel button that corresponds to a
Direct Access display.
This message appears when you try to perform an operation (such as song data conver-
sion) that cannot be performed during recording or playback.
➾Stop song recording or playback, or exit the Song Record or Song Play mode, then
perform the operation again.
This prompt appears when there is no disk in the disk drive.
➾Put the proper disk in the drive and attempt the operation again.
This prompt appears when you attempt to rename or convert a song that doesn’t contain
any data.
➾Select a song that contains data, or insert a disk with song data into the floppy disk
drive.
This message appears when you attempt to load, rename, or delete a file, and no file of
the specified type can be found on the disk in the disk drive.
➾Create a file or insert a disk with a proper file.
This message appears if you try to save a custom style to disk (page 82), but have se-
lected a memory number that doesn’t contain any style data.
➾Create a custom style, or select a memory number that contains custom style data.
This message appears when a new or improperly formatted disk has been inserted into
the disk drive. (See page 111.)
➾Press OK if you want to format the disk. Press CANCEL if you want to abort the
formatting process.
This message appears when you attempt to record or perform other file operations using a
disk whose write-protect tab is in the “protect” position.
➾
Set the write-protect tab to the “write-enable” position (page 112), then try the opera-
tion again. If the operation still cannot be performed, the disk itself has internal write
protection, making it impossible to perform recording or file operations on the disk.
Messages
● General (Panel Operation)
● General (Direct Access)
● General (Disk-related)
163