After indicating that data is being loaded, the Clavinova will begin to install the new version of the firmware. The following message is displayed at this time. Upgrading of the firmware takes approximately 5 minutes.
The USB flash memory device must not be unplugged and the instrument must not be turned off while the firmware is being installed. Failure to observe this precaution may render the Clavinova unfit for use.
The following message is displayed upon completion of the firmware installation process.
4. Turn off the Clavinova and unplug the USB flash memory device.
Reconfirming the Current Version
After any firmware upgrade, it is recommended that you confirm the current version once again as described below.
1. Turn on the Clavinova.
This can be done by pressing the Power switch located at the right of the front panel.
2. Confirm the instrument’s current firmware version as follows.
If the upgrade process has been completed successfully, version 1.10 will be shown in the window displayed. If the version has not changed, it is likely that the installation procedure was not completed successfully. In such a case, repeat the procedure carefully as described herein.
3. Press the [8▲] (EXIT) button or the [EXIT] button to close the window.
Deleting Upgrade Data
Deletion using the instrument:
Version 1.10 of the firmware for Clavinova
1. Plug the USB flash memory device containing the upgrade data into the Clavinova.
2. Hold down the [START/STOP] button and press the Power switch.
Continue to hold down the [START/STOP] button until the following message is displayed.
The USB flash memory device must not be unplugged and the instrument must not be turned off at this time. Failure to observe this precaution may render the Clavinova unfit for use.
3. Press the [BREAK] button to delete the upgrade data.
The following confirmation message will be displayed.
4. To delete the upgrade data, release the [START/ STOP] button and then press it once again.
The Clavinova will begin deleting the upgrade data. The following message is displayed at this time.
The USB flash memory device must not be unplugged and the instrument must not be turned off while the upgrade data is being deleted. Failure to observe this precaution may result in the USB flash memory device being permanently damaged.
The following message is displayed upon completion of the data deletion process.
5. Turn off the Clavinova and unplug the USB flash memory device.
This can be done by pressing the Power switch located at the right of the front panel.
2