21
Changing the Split Point
The split point can be set at any key by pressing the desired key while
holding the [SPLIT] button. The split point key name will appear in the
SPLIT POINT section of the display.
The split point can also be set by using the SPLIT POINT LCD but-
tons, or the data dial or [+]/[–] buttons once the SPLIT POINT section
of the display has been highlighted. The keyboard guide lamp corre-
sponding to the selected split point will light.
•The dual and split modes cannot be
used at the same time.
•Whether the damper pedal affects the
left voice only, the right voice only, or
both voices is determined by the
“DAMPER RANGE” function described
on page 93 (the default is right-hand
voice only).
•The OCTAVE SHIFT function — page
91 — can be used to shift the pitch of
the left- and/or right-hand voice in the
SPLIT mode up or down one octave.
•When the ABC Single Finger or Fin-
gered mode (page 35) and the split
mode are used simultaneously, the
left-hand voice will be accompanied by
the appropriate ABC chord voices.
•The SPLIT mode balance and split
point settings affect all voice combina-
tions.
•The SPLIT mode settings are retained
even if the SPLIT mode is turned off
and on while the power remains on.
The SPLIT mode settings can also be
backed up even after the power is
turned off via the “Backup” function —
page 107.
Split Mode
B
ASS DRUMS/
PERC. SPLIT
DUAL EFFECT
CLAVI. TONE/
SYNTH
U
ITAR
The default split point — F#2 — can be recalled by simultaneously
pressing the SPLIT POINT LCD buttons or [+] and [–] buttons.
The SPLIT mode can be turned off by pressing the [SPLIT] button so
that its indicator goes out.