References
Other Functions Connecting to an
External Device
Audio I/O
Connection
Connecting to
a Computer
Controls and
Connectors
Introduction to
the DME Satellite
Foreword
Connecting to an External Device
DME8i-C/DME8o-C/DME4io-C Owner’s Manual 33

Controlling the DME Satellite from a digital mixer Yamaha PM5D

If you install an MY16-C or MY16-CII interface card on a PM5D Digital Mixing Consol and connect it to the

DME Satellite via the CobraNet connectors, you can remotely control the DME Satellite from the PM5D, as well

as transfer audio and word clock signals between them. Refer to the PM5D/PM5D-RH Owner’s Manual for more

information on the PM5D’s DME Control function.

Network Connection ([NETWORK] Connectors

You can connect a controller such as the AMX or Crestron to DME Satellites via Ethernet, and remotely control

multiple DME Satellite units.

NOTE
•You can control multiple DME series units from a PM5D. Specify the same device group for each DME series unit you
want to control.
•If you have connected a PM5D and a DME Satellite via CobraNet and are controlling the DME Satellite from the PM5D,
you must specify a value of 2 as the fourth octet of the group master DME Satellite’s IP address.
NOTE
• The port used for remote control is specified from DME Designer. For details on making this setting, refer to the “DME
Designer Owner’s Manual.”
•Refer to “DME Remote Control Protocol Specifications” on the Yamaha web site for more information on communication
protocols used to control the DME Satellite from an external device (such as those from AMX or Crestron).
http://www.yamahaproaudio.com/
USB
PEAK
PEAK
SIGNAL
SIGNAL
PEAK
PEAK
SIGNAL
SIGNAL
PEAK
PEAK
SIGNAL
SIGNAL
INPUT
INPUT
DIGITAL MIXING ENGINE SATELLITE
USB
PEAK
PEAK
SIGNAL
SIGNAL
PEAK
PEAK
SIGNAL
SIGNAL
PEAK
PEAK
SIGNAL
SIGNAL
INPUT
INPUT
DIGITAL MIXING ENGINE SATELLITE
PM5D
MY16-CII
Ethernet
CobraNet
Ethernet Switching Hub
CobraNet Switching Hub
MY16-CII
Hub
Hub
Hub
DME8i-C
DME8i-C
DME8o-C
DME8o-C
DME4io-C
DME4io-C