6
How to use the DS60-112Before making any connections, make sure that the power is
switched OFF on the DS60-112 and all other devices.
OUTPUT
L/MONO
DS60-112DG-Stomp
INPUT
OUTPUT
DS60-112DG-1000
INPUT
GAIN
OUTPUT
L/MONO
SLAVE
OUT
INPUT
DS60-112DS60-112DG-Stomp, etc.INPUT
OUTPUT
L/MONO R
DS60-112DS60-112DG-Stomp
INPUTINPUT
L Side R Side
LINE OUT
R
DG60FX-112 DS60-112
INPUT
■Connecting a DG-Stomp
●Monaural Guitar Amplifier System
The Yamaha DG-Stomp is a guitar pre-amplifier unit with built-in effects.
Use a guitar cable to connect the DG-Stomp’s OUTPUT L/MONO jack
to the DS60-112’s INPUT jack to create a 60-watt guitar amplifier sys-
tem.
* Make sure the DG-Stomp’s Speaker Simulator is set to OFF.
●Stereo Guitar Amplifier System
Since the DG-Stomp is equipped with stereo outputs, it is possible to set
up a stereo (60W x 60W) guitar amplifier system by connecting a DS60-
112 to the DG-Stomp’s OUTPUT L/MONO jack, and another DS60-112
to the DG-Stomp’s OUTPUT R jack.
■Connecting a DG-1000
The Yamaha DG-1000 is a guitar pre-amplifier. Use a guitar cable to
connect the DG-1000’s OUTPUT jack to the DS60-112’s INPUT jack to
create a 60-watt guitar amplifier system.
■Connecting a DG60FX-112
Since the DG60FX-112’s speaker uses the same signal that is supplied
to its LINE OUT L jack, connecting the DG60FX-112’s LINE OUT R jack
to the DS60-112’s INPUT jack creates a 60W x 60W stereo guitar ampli-
fier system.
* Connecting the DG60FX-112’s LINE OUT L jack to the DS60-112’s IN-
PUT jack creates a 120W monaural guitar amplifier system.
■Using Multiple DS60-112s
Connect the DS60-112’s SLAVE OUT jack to another DS60-112’s IN-
PUT jack to create a 120W high power guitar amplifier system. You can
increase the amount of power by connecting three, four, or more units in
the same manner.
■Connecting Other Devices
The DS60-112 can also be used with a pre-amplifier or other device,
other than the DG-Stomp, DG-1000 or DG60FX-112. Use a guitar cable
to connect the device’s output jack to the DS60-112’s INPUT jack.