Preparation
Inserting batteries into the Remote Control
1Open the battery cover by pressing in the tab, then lift off the cover.
2Insert batteries with the correct polarity as indicated by the + and - symbols inside the battery compartment.
3Close the cover.
- | + |
+ | - |
CAUTION!
–Remove batteries if they are exhausted or not to be used for a long time.
–Do not use old and new or different types of batteries in combination.
–Batteries contain chemical substances, so they should be disposed off properly and kept away from children.
Using the Remote Control
●Direct the remote control at the remote sensor of the DVD player.
●Do not drop or give the remote control a shock.
●Do not leave the remote control in extremely hot or humid places.
●Do not spill water or put anything wet on the remote control.
NTSC/PAL Conversion
This player is equipped with a NTSC/PAL conversion feature to convert the video output of the disc to match your TV system. The conversions supported are as below. To activate the conversion, refer to “TV TYPE”:
| Disc | Output format | |||
Type |
| Format | Selected mode | ||
| NTSC | PAL | MULTI | ||
|
|
| |||
DVD |
| NTSC | NTSC | PAL | NTSC |
| PAL | NTSC | PAL | PAL | |
|
| ||||
VCD |
| NTSC | NTSC | PAL | NTSC |
|
|
|
|
| |
| PAL | NTSC | PAL | PAL | |
|
| ||||
Notes:
–“MULTI” can only be selected when using a TV that has both the NTSC and PAL systems.
–Slight picture distortions may occur due to this conversion. This is normal. Thus, the “MULTI” is most suitable for the best picture quality.
Turning on the power
1Connect the AC power cord to the power outlet.
2Turn on the TV and your AV receiver.
3Select the appropriate input source at the AV receiver that was used to connect to this unit. Refer to the equipment owner’s manual for detail.
4Turn this unit on.
5Set the TV to the correct Video IN channel. (eg. EXT1, EXT2, AV1, AV2, AUDIO/VIDEO, etc. (Refer to your TV owner’s manual for detail)
➜ The front display lights up and the default screen appears on the TV.
English
Smart Power On/Off
When in STOP mode, the DVD player will switch to standby mode after 15 minutes without any operations for saving energy. It is easily reactivated by pressing the POWER or PLAY on the remote control or the STANDBY/ON button on the front panel.
7