Yamaha EMX212S, EMX312SC Tilting, Rack Mounting

Horizontal Orientation, Tilting and Rack Mounting

EMX512SC/EMX312SC/EMX212S 29

Tilting

You can set the EMX unit at an angle, as shown below. Do not push too forcefully when tilting the unit. Excess

force may cause the unit to topple or turn, potentially

resulting in equipment damage or in injury to bystand-

ers.

Rack Mounting

To prepare the unit for rack mounting, use the (separately sold) RK512 rack mount kit.

If rack-mounting the unit, be sure to maintain adequate ventilation so the unit does not overheat. Consider attaching a vent panel,

and do not use a sealed rack.

The EMX unit requires 7U of rack space.

■How to install the rack-mount hardware

Turn the EMX unit upside down.

Using the kit’s 4 screws, attach the kit’s 2 metal ﬁttings

as shown below.

Turn the EMX right-side up.

NOTE

Screws

Fittings

RK512 Rack mount Kit

Contents

Main 2 Explanation of Graphical Symbols IMPORTANT SAFETY INSTRUCTIONS CAUTION PRECAUTIONS PLEASE READ CAREFULLY BEFORE PROCEEDING Do not open * Please keep this manual in a safe place for future reference. WARNING FCC INFORMATION (U.S.A.) About this Manual Mixer Basics (starts on page 6) EMX Setup and Operation (starts on page 20) IMPORTANT NOTICE FOR THE UNITED KINGDOM Basic Contents Features Quick Guide 6 Making the Most of Your Mixer 13 Reference 1 2 3 Turning the Unit On and Off 1 RIGHT WRONG!! 1 (microphones, instruments, etc.) Getting Sound to the Speakers Page 4 the LINE/MIC switch on each channel accordingly. 5 your inputs, set the PHANTOM switch to the ON position (). 7 tion. as necessary to adjust the overall output level. 8 9 1 depth for each channel. 2 To select a reverb effect, turn the dial to any value from 1 to 7. 3 4 overall effect depth. Using the Compressors to Enhance Vocals 1 (EMX512SC and EMX312SC only) Making the Most of Your Mixer An Introduction A Place for Everything and Everything in its Place A Plethora of ConnectorsWhat Goes Where? 14 Balanced, UnbalancedWhats the Difference? How Do Balanced Lines Reject Noise? A balanced cable has three conductors: To summarize Signal Levels and the Decibel Making Better Mixes 60 dBu Approaching the MixWhere Do You Start? Faders Down To EQ or Not to EQ Cut for a Cleaner Mix Boost with Caution Ambience Reverb and Delay Time Reverb Tone Reverb Level The Modulation Effects: Phasing, Chorus, and Flanging Compression Music FirstThen Mix Controls and Connectors Controls on Each Channel 6 7 8 9 22 Digital Effects Section 0 A 0 D MAIN Section MONITOR Section POWER Section P Q U R Rear Panel 2+ 2- V W X Connecting Speakers Page Horizontal Orientation, Tilting and Rack Mounting Tilting Rack Mounting How to install the rack-mount hardware Setting Up Setting Up Monitor Speakers Synthesizer Drums 1 Troubleshooting Specications General Specications Input Characteristics Output Characteristics Dimensional Diagrams Unit: mm Page http://www.yamaha.co.jp/manual/ CANADA U.S.A. MEXICO NORTH AMERICA CENTRAL & SOUTH AMERICA EUROPE AFRICA MIDDLE EAST ASIA OCEANIA