Yamaha EMX68s, EMX88s EMX88S/EMX68S Quick Guide

EMX88S/EMX68S Quick Guide

EMX88S/EMX68S—Owner’s Manual

EMX88S/EMX68S Quick Guide

The following steps (1–5) explain the basic con-

nection and operation of the EMX88S/EMX68S.

Also, please read “Front and Rear Panel” and

“Basic Operation” following this Quick Guide

section to learn more about using the EMX88S/

EMX68S.

Connecting speakers

Using speaker cables, connect each speaker to the

SPEAKERS A 1 jack and to the B 1 jack in the

SPEAKERS jack section on the rear panel of the

EMX88S/EMX68S.

• The diagram above shows an example of connecting

two main speakers. Refer to pages 17–18 for other

connection examples.

• You may connect to either of the two jacks on the

speakers.

• Be sure to use a cable designed for speaker connec-

tion.

Never connect the speakers in the manner shown

below. Otherwise, the EMX88S/EMX68S’s built-

in power ampliﬁer will be damaged.

Setting the power ampliﬁer mode

Set the power amp select switch (located on the

right corner on the panel) to MAIN L-R.

• This Quick Guide assumes that two main speakers

are connected. Refer to pages 13, 17, 18 for other

connections and power amp select switch settings.

• When the power amp select switch is set to the

MAIN L-R position, the stereo L signal will be out-

put from the SPEAKERS A jacks, and the stereo R

signal will be output from the SPEAKERS B jacks.

EMX88S (EMX68S)

Power amp select switch