Quick Guide — Advanced Course
Using as a Master Keyboard
140 Owner’s Manual
Assigning Control Change numbers to the Knobs/Sliders for each Zone
Here in the KN/CS display of the Master Edit mode, you can set how the Control Knobs and Sliders will affect each Zone. This
lets you specify a separate MIDI Control Change number for each Knob and Slider.
Set the parameters as shown below, corresponding to step #6 on page 138.
In the example above, the Control Knobs for all Zones have been set to 10 (Pan), and the Sliders have been set to 11
(Expression). In this way, you can control the stereo position of each Zone with the appropriate Knob, and use the Sliders to
adjust the relative volume balance among the Zones.
KNOB
CONTROL
FUNCTION
MASTER
VOLUME
SWING
CUTOFF
PAN
ASSIGN A
GATE TIME
RESONANCE
REVERB
ASSIGN B
VELOCITY
ATTACK
CHORUS
ASSIGN 1
UNITMULTIPLY
RELEASE
TEMPO
ASSIGN 2
LOW
KN 1
LOW MID
KN 2
HIGH MID
KN 3
HIGH
KN 4
ARP FX
EQ
TONE
ASSIGN
PAN/SEND
ZONE 1
CS 1
ZONE 1 ZONE 1 ZONE 1ZONE 1
CS 1 CS 2
ZONE 2
CS 3
ZONE 3
CS 4
ZONE 4
VOLUME 1VOLUME 1VOLUME 1VOLUME 1VOLUME 1VOLUME 2VOLUME 3VOLUME 4
All indicators are turned off by setting the
[MASTER] → [EDIT] → [COMMON] → [F2] OTHER
→ Knob/Slider parameter to “zone.”
You can determine which Control Change numbers are used for the Knobs
and Sliders for each zone in the [MASTER] → [EDIT] → Zone selection →
[F5] KN/CS display.