Yamaha EX5, EX5R, EX7

171

Performance Mode

Knob

■Knob To TG (Knob To Tone Generator)

When making bank/program changes, this sets

whether or not the preset values for Knobs 1-6 are

sent to the tone generator. When set to “on” the

messages are sent, and when set to “off” they are not

sent.

❏ Settings: off, on

■Knob To MIDI

When making bank/program changes, this sets

whether or not the preset values for Knobs 1-6 are

sent to an external MIDI device. When set to “on”

the messages are sent, and when set to “off” they are

not sent.

❏ Settings: off, on

■InitVal KN1~6 (Initial Values KN1~6)

Sets the control change preset values that are sent by

the Knobs 1-6.

❏ Settings: Each of the Knobs 1-6 can be set from 0~127

The contents of the control change for each controller

and Knobs 1-6 are designated in the CTRL screen.

Auditioning the Settings Done in the Preset Menu

The EX will output the parameter settings done in the

preset menu when you press [ENTER] key while

holding [SHIFT] key. You can audition the results.

[F3]: MLT (Multi)

Setting the parameters for each part in each

Performances is achieved in the chart. Various parts

can be displayed simultaneously and each can be

edited. Available parameters are the same as for those

explained for the PART screen, page 164.

When the MLT menu is selected with [F3], the

following five types of category menus are displayed.

You can easily scroll through the list and select the

desired parameter using the [F4]~[F8] keys.

[F4]: MIX (Settings related to MIX)

[F5]: LYR (Settings related to Layers)

[F6]: SOUND (Settings related to Sound)

[F7]: CTRL (Settings related to the Controllers)

[F8]: PRE (Settings related to the Presets)

Each time [F3] is pressed the Part section changes to

show the Part 1~4, Part 5~10 and Part 11~16,

alternately.

“Lyr” column allows you to adjust the overall settings

(such as volume and pan) for the parts which “Layer

Switches” (LYR menu) are turned on. You can adjust

each setting with the relative values among the balance

of the parts kept.

In the MLT screen, you can directly select the Part that

you want to edit by using the PART keys 1-16 on the panel

(EX5/7).

The available parameters are listed below. For

information about each parameter’s contents and

available values, see the explanation for the PART

screen (page 164).

Lyr~Part 1~4

Part 5~10

Part 11~16

Performance/E/qx 5/21/98 11:35 AM Page 171