289
6Connect the ASIB1 power cable that was set aside in
step 4to the CN2 connector (next to the TERM
switch) on the ASIB1. Be careful not to connect the
connector in the wrong direction.
7Check the location of the SCSI connector in the
EX5R (shown in the illustration), and connect the
ASIB1 and the EX5R with the SCSI cable. “SCSI” is
printed on the panel next to the SCSI connector.
8Support the ASB1 with your hand and use the two
screws removed in step 1to attach the board to the
rear panel of the EX5R.
ON TERM OFF
9Use the bundle tie next to the ASIB1 to bundle the
cables together.
)Replace the EX5R top cover. See How to Replace the
EX5R Top Cover.
For information on SCSI ID settings, see the Utility mode
(page 276).
ON TERM OFF
ON TERM OFF
Bundle tie
Appendix
Option/E/qx 5/21/98 11:58 AM Page 289