TROUBLESHOOTING

■Remote control

Problem

Cause

Remedy

Refer to

page

 

 

 

 

 

 

 

The remote control

Wrong distance or angle.

The remote control will function within a

8

does not work nor

 

maximum range of 6 m (20 feet) and no more

 

function properly.

 

than 30 degrees off-axis from the front panel.

 

 

 

 

 

 

Direct sunlight or lighting (from an

Reposition the unit.

—

 

inverter type of fluorescent lamp, etc.) is

 

 

 

striking the remote control sensor of this

 

 

 

unit.

 

 

 

 

 

 

 

The batteries are weak.

Replace all batteries with new ones.

3

 

 

 

 

The unit or other

The component to be controlled has not been

Set the selector dial to the appropriate position,

46

component cannot be

selected.

corresponding to the component to be

 

controlled.

 

controlled.

 

 

 

 

 

 

The remote control cannot control system

 

—

 

components.

 

 

 

The manufacturer code has not been set up

Enter the code again.

51

 

properly.

 

 

 

Try setting another code for the same

 

 

 

 

 

 

manufacturer.

 

 

 

 

 

 

Depending on the manufacturer or the

Program functions from the other remote

52

 

model, some components cannot be

control’s function into this remote control.

 

 

controlled with this unit’s remote control

 

 

 

even though the code has been set up

 

 

 

properly.

 

 

 

 

 

 

The remote control

The batteries of this remote control and/or

Replace the batteries.

3

does not “learn” new

the other remote control are too weak.

 

 

functions.

 

 

 

The distance between the two remote

Place the remote controls at the proper

52

 

 

controls is too much or too little.

distance.

 

 

 

 

 

 

The signal coding or modulation of the

Learning is not possible.

52

 

other remote control is not compatible with

 

 

 

this remote control.

 

 

 

 

 

 

 

Memory capacity is full.

Further learning is not possible without

52

 

 

deleting unnecessary functions.

 

 

 

 

 

After this unit has been exposed to a strong external electric shock (such as lightning and strong static electricity) or if you mishandle the operation of this unit, it may not function properly. In these cases, set this unit in the standby mode, disconnect the power cord, plug it back in after 30 seconds, and start operating.

70