28 En
Connections
■AC OUTLETS (SWITCHED)
Use these 2 outlets to supply power to any connected
components. Connect the power cable of your other
components to these 2 outlets. Power to these 2 outlets is
supplied when this unit is turned on. However, power to
these 2 outlets is cut off when this unit is turned off. For
information on the maximum power or the total power
consumption of the components that can be connected to
these 2 outlets, see “Specifications” on page 124.
The power to AC OUTLETS of this unit is not cut off while this
unit is charging connected iPod even when this unit is in the
standby mode. When this unit completes charging or the iPod is
disconnected, the power is cut off automatically when this unit is
in the standby mode.
1Press LSYSTEM OFF on the front panel to
turn off this unit.
See page 29 for details.
2Press and hold MTONE CONTROL and
then press KMAIN ZONE ON/OFF to turn
on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3Rotate the NPROGRAM selector to select
“SP IMP.”.
“SP IMP.” and the current speaker impedance setting
(“8Ω MIN”) appear in the front panel display.
4Press MTONE CONTROL repeatedly to
select “6Ω MIN”.
5Press LSYSTEM OFF to save the new
setting and turn off this unit.
The setting you made is reflected next time you turn on this
unit.
Connecting the power cable
Note
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby mode.
However, the stored data will be lost in case the power
cable is disconnected from the AC wall outlet or if the
power supply is cut off for more than one week.
AC OUTLETS
SWITCHED
120V 80Hz
100W MAX. TOTAL
0.8A MAX. TOTAL
DVRMONITOR OUT
C
To the AC wall outlet
Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to
“6Ω MIN” as follows BEFORE using this unit. 4 ohm
speakers can be also used as the front speakers.
Note
TONE CONTROL
ON/OFF
MAIN ZONE
While holding
down