5
ENGLISH

Rear Panel

1POWER Switch
Turns power to the MSR100 on and off. When the
power is turned on the POWER indicator (J)
will light green.
2INPUT1 Connector
This dual-mode input connector is a balanced
XLR-3-31 type.
The INPUT1 connector can be set for two types of
input: when the sensitivity switch (C) is set to
MIC microphone-level signals can be connected
directly to the input; when the sensitivity switch
(C) is set to LINE the input accepts line-level sig-
nals such as those from a preamplifier or mixer.
3Sensitivity Switch
Use this switch to set the sensitivity of the
INPUT1 connector to match MIC (microphone-
level) or LINE (line-level) input signals.
4INPUT2 and INPUT3 Connectors
The INPUT2 and INPUT3 connectors are unbal-
anced phone jacks for direct connection of line-
level audio signals and musical instruments.
5LEVEL Controls
Adjust the level of the signals received at the
INPUT1, INPUT2, and INPUT3 connectors (2,
4).
6EQ Controls
HIGH: The HIGH control adjusts the output level at
10 kHz over a ±6 dB range. Rotate clockwise to
boost or counterclockwise to cut.
LOW: The LOW control adjusts the output level at
60 Hz over a ±3 dB range. Rotate clockwise to
boost or counterclockwise to cut.
7LINK OUT Connector
This is a “direct output“ connector that outputs a
mix of the signals received at the INPUT1,
INPUT2 and INPUT3 connectors (2, 4).
8MASTER LEVEL Control
Adjusts the overall output level.
9CLIP Indicator
The CLIP indicator will light red if excessively
high signal levels cause amplifier clipping. If this
occurs, reduce the level of LEVEL controls (5) or
MASTER LEVEL controls (8).
JPOWER Indicator
Light green when the POWER switch (A) is
turned on.
KAC IN Connector
Connect the supplied power cord here.