CONTROL PARTS AND THEIR FUNCTIONS

FRONT PANEL

➊

SPEAKERS

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

➋

REAR PANEL

 

 

 

 

 

 

<MX-1>

 

<MX-2>

 

 

➌

 

➌

LEVEL

LEVEL INPUT

REMOTE CONTROL

REMOTE CONTROL

( PRE AMP )

( PRE AMP )

 

INPUT

➊POWER switch/indicator (POWER)

Press this switch to switch ON the power. The indicator will illuminate while the power is ON.

Press the switch again to switch OFF the power. Note the following cautions.

●Before switching ON the power, be sure to set the volume control of the pre-amplifier to the lowest setting in order to avoid damage to the speakers.

●The speaker-protection circuit functions to mute speaker sound reproduction for a few seconds after the power is switched ON.

➋SPEAKERS switches

Because one or two speaker systems can be connected to this unit, these switches allow you to select speaker system A or B, or both at once.

➌Input level controls (LEVEL)

These controls adjust the level of signals input to this unit. Normally set these controls to the “10” (maximum) position, and adjust the whole sound output level with the VOLUME control of the pre-amplifier. However, if your speakers’ permissible music input power is not high enough or sounds from the speakers are distorted, turn these controls counterclockwise to decrease the level.

STANDBY mode (For Europe model only)

 

If the REMOTE CONTROL (PRE AMP) connector on the rear

Note

panel of this unit is connected to the corresponding connector

To turn the power off completely, disconnect the AC

of the pre-amplifier (CX-1 or CX-2), by turning the power off

power plug from the wall outlet.

with the POWER switch of the pre-amplifier, this unit is

 

switched to the STANDBY mode. (In this mode, the indicator

 

over the POWER switch is half illuminated.)

 

6