CONNECTIONS TO YOUR AMPLIFIER

English

Before making connections, make sure that the amplifier is switched off.

■CONNECTIONS

•Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of the amplifier (or receiver) with the speaker cable.

•One side of the speaker cable is red and the other side is black. Connect the (+) terminals on the amplifier (or receiver) and speakers using the red side. Connect the

(–) terminals on both components using the black side of the cable.

•Connect one speaker to the left (marked L) terminals of your amplifier, and another speaker to the right (marked R) terminals, making sure not to reverse the polarity

(+, –). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass.

How to Connect:

1Loosen the knob.

2Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.

3Insert the bare wire.

4Tighten the knob and secure the cables.

Test the firmness of the connection by pulling lightly on the cables at the terminal.

 

4

Black

Speaker (R)

Speaker (L)

 

1

 

3

RedRed

RL

 

 

+

+

Speaker output

–

–

terminals of the

 

SPEAKERS

amplifier (or

 

 

receiver)

Black

 

Black

 

 

Amplifier or

Receiver

Note

Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both of them.

When using a banana plug <General model only>

1Remove the cover by pulling it toward you.

2 Tighten the terminal knob.

3 Simply insert the banana plug into the terminal.

Banana plug 3

21

■Using the non-skid pads

Put the provided non-skid pads at the four corners on the bottom of speaker to prevent the speaker from moving by vibrations etc.

Non-skid pad

E-2