Yamaha NS-5290, NS-5295, NS-6390, NS-6395 CONNECTIONS TO YOUR AMPLIFIER, REMOVING THE FRONT COVER, SPECIFICATIONS, YAMAHA CORPORATION, ■Connections, ■ NS-6390/6395, ■ NS-5290/5295, is switched off

CONNECTIONS TO YOUR AMPLIFIER		REMOVING THE FRONT COVER
Before making connections, make sure that the amplifier		The front cover is fastened to the enclosure at four points, and
is switched off.		can be removed if desired. To remove the cover, hold on to
		both sides and slowly pull straight away from the speaker. To
		reattach, line up the four pegs on the inside surface of the
		cover with the four corresponding holes on the speaker and
	Red (+)	push gently.
	Red (+)
Black (+)
–	Press
–	+
	+
		(NS-6390/6395 shown)
		Note
Speaker (R)	Speaker (L)	When the cover is removed, take care not to touch the
		speaker units with your hands or to exert excessive force
		with tools.

		SPEAKERS
	R	L
Speakers output		A
Speakers output	+	– – +
terminals of the		B
amplifier		B
amplifier

Amplifier or

Receiver

■Connections

●Connect the push-type input terminals at the rear of the speakers to the speaker output terminals of your amplifier with the speaker cables.

●Connect the (+) terminals on both the amplifier and the speakers using one side of the cable. Connect the (–) terminals on both components using the other side of the cable.

●Connect one speaker to the left (marked L) terminals of your amplifier, and another speaker to the right (marked R) terminals, making sure not to reverse the polarity (+, –). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass.

Procedure:

1Press the lever on the speaker terminal down, as shown in the diagram.

2Insert the bare wire end properly into the terminal hole.

3Remove your finger from the lever to allow it to lock snugly on the cable’s wire end.

4Test the security of the connection by tugging lightly on the cable at the terminal.

Note

Do not let the bare speaker wires touch each other as this could damage the speaker and/or the amplifier.

SPECIFICATIONS

■ NS-6390/6395

Type .... 3-way acoustic suspension (Magnetically-shielded type)

Driver .............................................	20 cm (8") cone woofer
	10 cm (4") dome mid-range
	2 cm (3/4") balanced dome tweeter
Frequency response ...................................	45 Hz – 20 kHz
Nominal impedance .................................................	8 ohms
Nominal input power ...................................................	70 W
Maximum input power ...............................................	140 W
Sensitivity ....................................................	91 dB/2.83 V/m
Crossover frequency ....................................	2.5 kHz, 8 kHz
Dimensions (W x H x D) ......................	267 x 411 x 336 mm
	(10-1/2"x 16-1/5" x 13-1/5")
Weight ...........................................................	6 kg (13.2 lbs)
Accessories...................................	Speaker cable 2.5 m x 2

■ NS-5290/5295

Type .... 2-way acoustic suspension (Magnetically-shielded type)

Driver .......................................	16 cm (6-1/2") cone woofer
	2 cm (3/4") balanced dome tweeter
Frequency response ...................................	60 Hz – 20 kHz
Nominal impedance .................................................	8 ohms
Nominal input power ...................................................	30 W
Maximum input power .................................................	60 W
Sensitivity ....................................................	90 dB/2.83 V/m
Crossover frequency ..................................................	4 kHz
Dimensions (W x H x D) ......................	203 x 305 x 250 mm
	(8"x 12" x 9-4/5")
Weight ..........................................................	3.4 kg (7.5 lbs)
Accessories...................................	Speaker cable 2.5 m x 2

●Specifications subject to change without notice due to product improvements.

●Care should be taken not to exceed the input power values noted above.

YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A.

YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA

YAMAHA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, F.R. OF GERMANY

YAMAHA ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD1 7JS, ENGLAND

YAMAHA SCANDINAVIAA.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH MELBOURNE, 3205 VIC., AUSTRALIA

CONNECTIONS TO YOUR AMPLIFIER

REMOVING THE FRONT COVER

Before making connections, make sure that the amplifier

is switched off.

can be removed if desired. To remove the cover, hold on to

reattach, line up the four pegs on the inside surface of the

cover with the four corresponding holes on the speaker and

push gently.

(NS-6390/6395 shown)

Note

Speaker (R)

Speaker (L)

When the cover is removed, take care not to touch the

speaker units with your hands or to exert excessive force

with tools.

SPEAKERS

Speakers output

terminals of the

amplifier

Amplifier or

Receiver

■Connections

Procedure:

1Press the lever on the speaker terminal down, as shown in the diagram.

2Insert the bare wire end properly into the terminal hole.

SPECIFICATIONS

■ NS-6390/6395

Type .... 3-way acoustic suspension (Magnetically-shielded type)

20 cm (8") cone woofer

10 cm (4") dome mid-range

45 Hz – 20 kHz

8 ohms

91 dB/2.83 V/m

2.5 kHz, 8 kHz

267 x 411 x 336 mm

6 kg (13.2 lbs)

Speaker cable 2.5 m x 2

■ NS-5290/5295

Type .... 2-way acoustic suspension (Magnetically-shielded type)

16 cm (6-1/2") cone woofer

60 Hz – 20 kHz

90 dB/2.83 V/m

4 kHz

203 x 305 x 250 mm

3.4 kg (7.5 lbs)

●Specifications subject to change without notice due to product improvements.

●Care should be taken not to exceed the input power values noted above.

YAMAHA CORPORATION

Printed in Indonesia V700620