.

ATTACHING THE STANDS

When placing the speakers, be sure to use the stands to increase stability.

(L)(R)

Stand (R x 2, L x 2)

Pad x 4

Washer x 4

Screw

 

 

 

 

(25mm) x 8

Note

The provided stands are in two types. Two stands are for the right side and others are for the left side. Attach each stand to the proper position on the bottom of the speaker by following the figure below.

View from the bottom of the speaker

(L)

Back

(R)

Procedure:

1First, put the screw through the washer, then through the inner hole of the stand, and screw it into the outside hole of the speaker. Do not tighten too much at this point.

Outer hole

Inner hole

2Put a screw through the outer hole on the stand, and screw it into the other hole on the base of the speaker.

3Tighten both of the screws firmly.

4Attach a pad to the bottom of the end portion of the stand.

5Attach the other stands to the other corners of the base of the speaker in the same way and confirm that all 4 stands have been firmly attached.

(R)

(L)

Front

Use the 8 specified holes located on the base of the speaker.

12

Note

Be carefull not to apply force to the side of the speaker, otherwise the speaker may fall causing damage to the speaker or personal injury.

2