SETTING UP THE SPEAKERS

Stand mounting the front speakers

You can use the supplied speaker stands SPS-9500T for table top installation. For assembly instructions, please refer to the SPS-9500T owner’s manual which can be found in the SPS-9500T box.

Wall mounting the front speakers

The front speakers may also be hung on a wall, utilizing the key holes on the rear of the speakers.

Use the key hole

* Do not use this screw hole.

The screw holes are designed specifically for use with the inch screws supplied with the SPS-9500T speaker stands.

Wall / wall support

Tapping screw (Available at the hardware store)

 

Screw

 

diameter

*a

1/8”-3/16”

*b

(4-4.5 mm)

*a: Min 1-1/2” (38 mm)

*b: 7/32” (5.5 mm)

Use the key hole

Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the rear of the speaker on the protruding screws.

Make sure that the screws are securely caught by the narrow sections of the “key hole” opening.

 

WARNING

 

The front speakers weigh 7.92 lbs (3.6 kg) each. Do not mount them on thin plywood or a wall with soft

 

surface material. If mounted, the screws may come out of the flimsy surface and the speakers may fall.

 

This will damage the speakers and can cause personal injury.

 

Do not fasten the speaker to a wall with nails, adhesives, or any other unstable hardware. Long-term use

 

and vibrations may cause them to fall.

 

To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or

 

floor molding.

4

Secure installation is the purchaser’s responsibility.