■Placing the center speaker NS-C125

Place the speaker on the floor under the TV or inside the TV rack so that it is stabilized.

When placing the speaker on top of the TV

To prevent the speaker from falling down, put the provided fasteners at two points on both bottom of the speaker and top of the TV.

NS-C125Peel off the seal

1 2

FastenerTV setNotes:

•Do not place the speaker on top of the TV whose area is smaller than the bottom area of the speaker. If placed, the speaker may drop out causing an injury to you.

•Do not place the speaker on top of the TV with an inclination.

•Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength.

•Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop.

■Mounting the center speaker NS-C125 on the wall

The speaker can be mounted on a wall by using the bracket attached to the speaker’s back panel.

Holes

Make sure that the screws are caught by a narrow part of the holes securely.

292mm (11-1/2”)

Fasten screws into a firm wall or wall support as shown in the figure below, and hang the holes on the protruding screws.

NS-C125

 

Diam. 3.5 to

 

4 mm (1/8”)

 

Min.

 

20 mm

 

(3/4”)

 

3 mm
Wall or wall(1/8”)

Tapping screw

support

 

(commercially

 

available)

WARNING:

•The speaker weights 2 kg (4.4 lbs). Do not mount them on thin plywood or soft wall surface material, as the screws may come out of the flimsy surface, causing the speakers to fall down and be damaged, or result in personal injury.

•Do not fasten the speakers to wall with nails, adhesives, or other unsound hardware. Long term use and vibrations may cause them to fall down.

•To avoid accidents resulting from tripping over loose speaker cords, fix them to the wall.

E-4