English

E-3

Place the speaker on the TV whose top is flat or on the floor
under the TV or inside the TV rack so that it is stabilized.
When placing the speaker on top of the TV, to prevent the
speaker from falling down, put the provided fasteners at two
points on both bottom of the speaker and top of the TV.
䡵Placing the center speaker
Fastener
TV set
The speakers can be mounted on a wall by using the
bracket attached to the speakers’ back panels.
Make sure that the screws are caught by a narrow part of
the holes securely.
Put the screws into a wall according to the figure shown
below.
䡵Mounting the rear and rear center speakers on the wall
Holes
Pads
Fasten screws into a firm wall or wall support as shown in
the figure below, and hang the holes on the protruding
screws.
WARNING
●Each speaker weights 2.3 kg (5 lbs. 2 oz.). Do not
mount them on thin plywood or soft wall surface
material, as the screws may come out of the flimsy
surface, causing the speakers to fall down and be
damaged, or result in personal injury.
●Do not fasten the speakers to wall with nails,
adhesives, or other unsound hardware. Long term
use and vibrations may cause them to fall down.
●To avoid accidents resulting from tripping over loose
speaker cords, fix them to the wall.
40 mm
Diam. 3.5 to 4 mm
Min.
20 mm
3 mm
Tapping screw
(available at a
hardware store)
Notes●Do not place the speaker on top of the TV whose
area is smaller than the bottom area of the speaker.
If placed, the speaker may drop out causing an
injury to you.
●Do not place the speaker on top of the TV with an
inclination.
●Do not touch the adhesive surface after peeling off
the seal as this will weaken its adhesive strength.
●Thoroughly wipe clean the surface where the
fastener is to be applied. Note that adhesive strength
is weakened if the surface is dirty, oily or wet and
that this may cause the center speaker to drop.
Screen
Wall or wall
support
Peel off
the seal
NS-P70 ENG(02.2.22)a 02.2.27, 8:12 PM3