E-12
1Set the VOLUME control of the amplifier to
minimum (0).
2Turn on the power of all the other
components.
3Press the STANDBY/ON button to turn on
the subwoofer.
4Play a source and adjust the amplifier’s
volume control to the desired listening level.
5Adjust the HIGH CUT control to the position
where the desired response can be
obtained.
This system is designed so that the optimum tone
balance between the subwoofer and the main speakers
(NS-10MMT) is obtained when this control is set at 110
Hz. However, the tone balance may change depending
on the room size, the distance from the subwoofer to
the main speakers, etc. So, if you prefer, turn the HIGH
CUT control and set it to a position where a better tone
balance is obtained.
䡵 Adjusting the subwoofer before use
Before using the subwoofer, adjust the subwoofer to obtain the optimum volume and tone balance between the subwoofer and
the main speakers by following the procedures described below.
6Increase the volume gradually to adjust the
volume balance between the subwoofer and
the main speakers.
Once the volume balance between the subwoofer and
the main speakers is adjusted, you can adjust the
volume of your whole sound system by using the
amplifier’s volume control.
However, if you change the main speakers NS-10MMT
to others, you must make this adjustment again.
SUPERWOOFER SYSTEM YST-SW45
HIGH CUTSTANDBY/ON
150Hz50Hz
VOLUME
100
150 Hz
010
50 Hz
STANDBY/ON HIGH CUT VOLUME
Front panel
653