CONNECTIONS TO YOUR AMPLIFIER
Before making connections, make sure that the amplifier is switched off.
Connections
•Connect the input terminals at the rear of the speakers to the speaker output terminals of the amplifier (or receiver) with the provided speaker cables.
•Connect the (+) terminals on both the amplifier (or receiver) and the speakers using one side of the cable. Connect the
•Connect one speaker to the left (marked L) terminals of the amplifier (or receiver) , and another speaker to the right (marked R) terminals, making sure not to reverse the polarity (+,
How to Connect: |
|
|
|
[U.S.A. Model] |
| [Europe, China and General models] | |
|
| ||
|
|
| Loosen |
| Red (+) |
| Tighten |
Black |
| Black |
|
|
|
| |
| Press |
| Red (+) |
|
|
| |
– | + |
|
|
|
|
| |
Speaker (R) | Speaker (L) | Speaker (R) | Speaker (L) |
| SPEAKERS |
| SPEAKERS | |||
| R |
|
| |||
| L |
|
|
| ||
Speakers output |
| A | Speakers output | R | L | |
|
| A | ||||
terminals of the | + – – | + |
| |||
terminals of the | + – – | + | ||||
amplifier |
| B | ||||
| amplifier |
| B | |||
|
|
| ||||
|
|
|
|
| ||
| Amplifier or |
| Amplifier or | |||
| Receiver |
|
| Receiver |
| |
1Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.
2Press and hold the terminal’s tab, as shown in the figure.3Release your finger from the tab to allow it to lock securely on the cable’s wire end.
4Test the firmness of the connection by pulling lightlyon the cable at the terminal.Note
Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both of them.
1Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.
2Loosen the terminal knob.3Insert the bare wire.4Tighten the knob and secure the cable. Test the firmness of the connection by pulling lightly on the
cable at the terminal.Note
Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both of them.
2