How to connect:

1Loosen the knob.

2Insert the bare wire. [Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.]

Good

No Good

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3Tighten the knob and secure the cable.

Test the firmness of the connection by pulling lightly on the cable at the terminal.

Note

Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both of them.

PLACING THE SPEAKERS

•Place the speakers on a sturdy, vibration-free surface. You may not be able to obtain good bass quality when the speakers are placed directly on the floor. Put a block, etc. under the speakers.

•Better stereo images will be obtained when the speakers are slightly angled in towards the listening position.

Note

These speakers feature a magnetically shielded design, but there is still a chance that placing them too close to a TV set might impair picture color. Should this happen, move the speakers away from the TV set.

REMOVING THE FRONT COVER

The front cover is fastened to the enclosure at four point and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker.

To reattach, line up the four pegs on the inner surface of the cover with the four corresponding holes on the speaker and push gently.

Note

When the cover is removed, be sure not to touch the speaker units with your hands or to exert excessive force with tools.

SPECIFICATIONS

Type .............................

2-way bass-reflex speaker system

 

 

(Magnetic shielding type)

Driver ...........................................

13 cm (5") cone woofer

 

 

2.5 cm (1") dome tweeter

Nominal Input Power ...............................................

60 W

Maximum Input Power ...........................................

110 W

Impedance ....................................................................

6 Ω

Frequency Response ................................

55 Hz – 28 kHz

Sensitivity ................................................

87 dB/2.83 V/m

Crossover Frequency ...............................................

3 kHz

Dimensions (W x H x D)

................. 186 x 300 x 222 mm

 

 

(7-5/16" x 11-13/16" x 8-3/4")

Weight ...........................................

4 kg (8 lbs. 13 oz.) x 2

Accessories ..................................

Speaker cable (4 m) x 2

*Please note that all specifications are subject to change without notice.

*Care should be taken not to exceed the input power values noted above.

3