Yamaha NX-E400 REMOVING THE FRONT COVER, SPECIFICATIONS, Note, Note, 3 kHz, RX-E400, 87 dB/2.83 V/m, How to connect:, 55 Hz to 28 kHz, 1Loosen the knob, 186 x 300 x 223 mm

Loosen

Tighten

Black (–)

Red (+)

Red line

Speaker (R) Speaker (L)

Red line

Black line

Speaker output terminals of

the receiver

RX-E400How to connect:1Loosen the knob.

2Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.

3Insert the bare wire.4Tighten the knob and secure the cable.

Test the firmness of the connection by pulling lightly on the cable at the terminal.

Note

Do not let the bare speaker wires touch each other as this could damage the speaker or the receiver, or both of them.

When using a banana plug

3 Banana plug

1

2

1Remove the cover by pulling it toward you.2 Tighten the terminal knob.3 Simply insert the banana plug into the terminal.

REMOVING THE FRONT COVER

The front cover is fastened to the enclosure at four point and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker.

To reattach, line up the four pegs on the inner surface of the cover with the four corresponding holes on the speaker and push gently.

Note

When the cover is removed, be sure not to touch the speaker units with your hands or to exert excessive force with tools.

SPECIFICATIONS
Type .............................................	2-way bass-reflex speaker system
	Magnetic shielding type
Driver ....................................................	13 cm (5-1/4") cone woofer
	2.5 cm (1") dome tweeter
Impedance ..................................................................................	6 Ω
Frequency Response ...............................................	55 Hz to 28 kHz
Nominal Input Power ...............................................................	60 W
Maximum Input Power ...........................................................	110 W
Sensitivity ................................................................	87 dB/2.83 V/m
Crossover Frequency ...............................................................	3 kHz
Dimensions (W x H x D) .................................	186 x 300 x 223 mm
	(7-5/16" x 11-13/16" x 8-13/16")
Weight .........................................................	4.3 kg (9 lbs. 8 oz.) x 2
Accessories .................................................	Speaker cable (4 m) x 2

*Specifications are subject to change without notice due to product improvements.

*Care should be taken not to exceed the input power values noted above.

3