ENGLISH
Precautions
POCKETRAK 2G Owner’s Manual
11
WARNING
• Do not remove the battery while the unit is in use.
Do not remove the battery while the unit is being used. Doing so
could corrupt the data or cause malfunctions.
• Do not leave the battery installed for an extended time.
If the battery runs out, or if the device is not to be used for a long
time (about one week), remove the battery from the device and
keep it in a dry and cool place to prevent possible leakage of the
battery fluid.
CAUTION
• Check the battery capacity before recording or deleting
recorded material
If the remaining battery capacity indication should run low during
recording, immediately stop recording, and recharge the battery or
install a fresh battery.
If the battery becomes exhausted during deletion, it will be
impossible to delete the recorded material.
CAUTION: for eneloop (Rechargeable Ni-MH Battery)
• Charge before use
If the eneloop battery becomes exhausted, you must charge it
before use. The battery may become warm during charging, but
this is not a malfunction.
Do not recharge conventional (alkaline) batteries.
When charging the battery outside this product, use a charger that
supports eneloop batteries, and observe the instructions given in
the “owner’s manual” for your charger.
• If the battery fluid leaks
If the battery does leak, avoid contact with the leaked fluid. If the
battery fluid should come in contact with your eyes, mouth, skin,
or clothes, wash immediately with water and consult a doctor.
Battery fluid is corrosive and may possibly cause loss of sight or
chemical burns. Also if your skin should become inflamed when
contacted by battery fluid, consult a doctor.
Always turn the power off when the device is not in use.
The performance of components with moving contacts, such as switches, volume controls, and connectors, deteriorates over time. Consult qualified
Yamaha service personnel about replacing defective components.
Make sure to discard used batteries according to local regulations.
For France, the included earphones has been tested to comply with the Sound Pressure Level requirement laid down in
NF EN 50332-1:2000 standard as required by French Article L. 5232-1.
Maximum output voltage: 150 mV
Wide band characteristic voltage for the included earphones: 75 mV or higher
Yamaha cannot be held responsible for damage caused by improper use or modifications to the device, or data that is lost or destroyed.
(5)-5