Setting Up
PSR-K1 Owner’s Manual 13
■Precautions concerning the microphone and microphone holder
Avoid leaning or putting any weight on the microphone holder.
Doing so may damage the holder and the connected microphone.
•When removing the microphone, pull it out of the handle toward you
(as shown).
•Do not pull on the microphone cable, or put anything on the micro-
phone when it is connected.
•Do not put any other microphones or anything other than the included
microphone in the microphone holder.
• Do not stand the instrument on its microphone holder side.
•Do not force the microphone when installing and do not shake it or
subject it to sudden, violent movement.
The microphone is equipped with an on/off switch. Make sure to leave it
off when not in use.
•If you insert the microphone with the switch side sliding past the handle,
the switch may inadvertently be turned on. Put the microphone in the
holder so that the switch slides into the space of the holder clasp (as
shown).
NOTE
If feedback occurs when using the microphone, turn down the [MICVOL-
UME].
Avoid placing the microphone in close proximity to the speakers, espe-
cially with the microphone facing the speaker. This can cause feedback.
• Feedback occurs when a microphone picks up the sound of a speaker,
which is then amplified and sent back to the speaker, creating an endless
loop of high-pitched noise.
NOTE
Do not swing the microphone by the microphone cable. In addition
to being dangerous to anyone near you, it can also damage the
cable and cut off the circuit.
Make sure to take the microphone out of its holder when you carry
the instrument. Also, when putting the instrument in a soft case,
make sure to take off the microphone holder.
Do not lift the instrument by grabbing the microphone and its
holder.