OUTPUT terminals (for driving speakers with external amplifiers)

OUTPUT

CENTER

SUB

WOOFER

CENTER OUTPUT terminal

This terminal is for center channel line output. There is no connection to this terminal when you use the built-in amplifier. However, if you drive a center speaker with an external power amplifier, connect the input terminal of the external amplifier to this terminal.

SUBWOOFER OUTPUT terminal

This terminal is for connecting with the input terminal of an amplifier for driving a subwoofer.

This terminal outputs only frequencies below 200 Hz from the main and center channels.

Note

Output level of signals from these terminals are adjusted

by the use of VOLUME control on the front panel or VOLUME keys on the remote control transmitter.

IMPEDANCE SELECTOR switch

Be sure to switch this only when the power of this unit is turned off.

Select the position whose requirements your speaker system meets.

IMPEDANCE SELECTOR

REAR 6ΩMIN./SPEAKER

CENTER SINGLE:6ΩMIN./SPEAKER

DUAL:3ΩMIN./SPEAKER

MAIN A OR B:4ΩMIN./SPEAKER

AB:8ΩMIN./SPEAKER

REAR 8ΩMIN./SPEAKER

CENTER SINGLE:8ΩMIN./SPEAKER

DUAL:4ΩMIN./SPEAKER

MAIN A OR B:8ΩMIN./SPEAKER

AB:I6ΩMIN./SPEAKER

(U.S.A. model)

(Upper position)

Rear: The impedance of each speaker must be 6Ω or higher.

Center: If you use one center speaker, the impedance of the speaker must be 6Ω or higher.

If you use two center speakers, the impedance of each speaker must be 3Ω or higher.

Main: If you use one pair of main speakers, the impedance of each speaker must be 4Ω or higher.

If you use two pairs of main speakers, the impedance of each speaker must be 8Ω or higher.

(Lower position)

Rear: The impedance of each speaker must be 8Ω or higher.

Center: If you use one center speaker, the impedance of the speaker must be 8Ω or higher.

If you use two center speakers, the impedance of each speaker must be 4Ω or higher.

Main: If you use one pair of main speakers, the impedance of each speaker must be 8Ω or higher.

<Except Canada model>

If you use two pairs of main speakers, the impedance of each speaker must be 16Ω or higher.

12