Yamaha RX-496RDS BASIC OPERATIONS, TO PLAY A SOURCE

From page 14 to 25, this manual describes how to operate this unit mainly by using the front panel control parts. To operate this unit on the remote control transmitter, use the corresponding keys on the remote control transmitter.

TO PLAY A SOURCE

BASIC OPERATIONS

2 3 7

	NATURAL SOUND STEREO RECEIVER																											PURE		DIRECT
																													VOLUME
																												20		l6
																						TUNER			PHONO	CD					l2
																											28		8
STANDBY/ON
																											40				4
																						AUX			TAPE 2	TAPE 1/MD	60				2
																									MONITOR
			A/B/C/D/E		1			2			3			4		5	6		7	8											0
																													–dB
PHONES		SPEAKERS			BASS					TREBLE				BALANCE			LOUDNESS
					l	0	l			l	0	l		l	0	l	l	FLAT	–30dB		FM/AM		DOWN TUNING UP
		A		B
					2			2	2				2	2		2	2		l0
					3			3	3				3	3		3	3		9		MEMORY		EDIT	TUNING
																									MODE
		ON		OFF	4			4	4				4	4		4	4		8
					5		5		5			5		L 5		5 R	5 6 7
																					MAN’L/AUTO FM			AUTO/MAN’L MONO

	: RX-496RDS and RX-496 only	4	7
1	VOLUME
	l6
	20	l2
	28	8
	40	4

602

0

–dB

Set to the “∞ ” position.

2 Turn the power on.

STANDBY/ON

3 Select the desired input source by using the input selector buttons.

TUNER PHONO CD

AUX	TAPE 2	TAPE 1/MD
	MONITOR

*The name of the selected input source will appear on the display.

4 Select the speakers to be used.

SPEAKERS

A B

ON

*If you use two speaker systems, press both the A and B switches.

1, 6

5 Play the source. (For detailed information on the tuning operation, refer to page 17.)

6	l6
	VOLUME
20	l2
28	8
40	4

602

0

–dB

Adjust to the desired output level.

7 If desired, adjust the BASS, TREBLE, BALANCE and LOUDNESS controls, or use the PURE DIRECT switch (for RX-496RDS and RX-496 only). For details, refer to page 16.

Notes on using the input selector buttons

●Note that pressing each input selector button selects the source which is connected to the corresponding input terminals on the rear panel.

●The selection of TAPE 2 MONITOR cannot be canceled by pressing another input selector button. To cancel it, press TAPE 2 MONITOR again so that the “TAPE MON 2” indicator disappears from the display.

When you select a button other than TAPE 2 MONITOR, make sure that the “TAPE MON 2” indicator is not illuminated on the display.

When you finish using this unit

Press the STANDBY/ON switch on the front panel again or the STANDBY/ON key on the remote control transmitter to turn this unit into the standby mode.

14