Yamaha RX-V3200 Setting the Manufacturer Code, 5 Press LEARN again to exit from the setup mode, 3 Press k / n to select the name of your component’s manufacturer

REMOTE CONTROL FEATURES

Setting the Manufacturer Code

You can control other components by setting a manufacturer code. A code can be set up in each component control area.

The following table shows factory-set component (Library: component category) and the manufacturer code for each area. If you are to make a setting for different component from the factory setting, change the library as described in step 3 on right.

Input area	Component category	Manufacturer
	(Library)

A	LD	YAMAHA

B	SATELLITE TUNER	–

PHONO	TV	–

TUNER	TUNER	YAMAHA

CD	CD	YAMAHA

V-AUX	VCR	–

CBL/SAT	CABLE	–

MD/TAPE	MD	YAMAHA

CD-R	CD-R	YAMAHA

D-TV/LD	TV	–

VCR 1	VCR	–

VCR 2/DVR	VCR	–

DVD	DVD	YAMAHA

1 Press an input selector button, Å or ı to select the source component you want to set up.

		A	B	PHONO
V-AUX	TUNER	MD/TAPE	CD-R	CD
D-TV/LD	CBL/SAT	VCR 1	VCR2/DVR	DVD

3 Press k / n to select the name of your component’s manufacturer.

You will find the names of most worldwide audio- video manufacturers in alphabetical order in the display window.

ENTER

If you want to change a library (component category), press l / h. You can set a different component from the input selector name.

Library choices: DVD, LD, CD, CD-R, MD, TAPE, TUNER, AMP, TV, CABLE, DBS, SAT, VCR

Note

If the manufacturer of your component has more than one codes, try each of them until you find the correct one as checking if it works following step 4.

4 Press one of the buttons shaded below to check if it works for the component being set. If it does, the manufacturer code setting has been correctly made.

				6CH INPUT
		TITLE
			ENTER
SOURCE
	DISPLAY	MENU		SOUND
SELECT	SEARCH		– CHAPTER +
POWER	REC	STOP	PAUSE	PLAY

2 Press and hold LEARN for about 3 seconds by using a ballpoint pen or similar object.

“SETUP” and the selected component name appear alternately in the display window.

LEARN

Notes

•Press LEARN for at least 3 seconds, otherwise the learning process is started.

•If you do not press any button within 30 seconds during step 3, the setup process is canceled. If this happens, start over from step 2.

•If you continuously want to set up another code for another component, press ENTER and repeat steps 1, 3 and 4.

5 Press LEARN again to exit from the setup mode.

LEARN

Notes

•If you have already programmed a remote control function for a button, the function by learning or macro programming takes priority over the setup manufacturer code’s function.

•“ERROR” appears in the display window under the following circumstances:

–when pressing a button other than the cursor and ENTER;

–when pressing more than one button at once; or

–when MACRO ON/OFF, 10KEY/DSP or PARAMETER/SET MENU is switched to another position.