Yamaha RX-V340RDS

English

PREPARATION

10 mm (3/8”)

Red: positive (+)

Black: negative (–)

Banana plug

CONNECTIONS

■Connections

Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) in accordance with the markers on

this unit, the speakers, and the speaker cables. If the connections are faulty, no sound will be heard from the speakers,

and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass.

CAUTION

• Use speakers with the specified impedance shown on the rear panel of this unit.

• Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/

or the speakers.

A speaker cord is actually a pair of insulated cables

running side by side. One cable is colored or shaped

differently, perhaps with a stripe, groove or ridge.

1Remove approximately 10 mm (3/8”) of

insulation from each of the speaker cables.

2Twist the exposed wires of the cable

together to prevent short circuits.

1Unscrew the knob.

2Insert one bare wire into the hole in the side

of each terminal.

3Tighten the knob to secure the wire.

(With the exception of U.K., Europe, Korea, and Singapore

models)

• You can also use banana plug connectors. First, tighten the

knob and then insert the banana plug connector into the end of

the corresponding terminal.

1Press and open the tab.

2Insert one bare wire into the hole of each

terminal.

3Release the tab to secure the wire.

(With the exception of U.K., Europe, Korea, and

Singapore models)

Connecting to the MAIN A SPEAKERS terminals

Red: positive (+)

Black: negative (–)

Connecting to the MAIN B, CENTER and REAR SPEAKERS terminals

04V340G_09-18_EN(03.3.12)a.p65 03.4.14, 11:49 AM15