For connecting speakers
Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and – markings are observed. If these wires are reversed, the sound will be unnatural and will lack bass.
Do not let the bare speaker wires touch each other and do not let them touch the metal parts of this unit as this could damage this unit and/or speakers.
Note
Use speakers with the specified impedance shown on the rear of this unit.
RX-V390 only
For connecting to the REAR and CENTER SPEAKERS terminals
Red: positive (+)
Black: negative
| ➀Press the tab. |
| ➁Insert the bare wire. |
➀ | [Remove approx. 5mm |
➁ | (1/4”) insulation from |
➂ | the speaker wires.] |
How to Connect:
Red: positive (+)
Black: negative
➁
➂
➀
➀Press and open the tab.
➁Insert the bare wire. [Remove approx. 5mm (1/4”) insulation from
the speaker wires.]
➂Press the tab back to the original position and secure the wire.
➂Release the tab and |
secure the wire. |
ABOUT THE ACCESSORY TERMINALS
AC OUTLET(S) (SWITCHED)
(U.S.A., Canada and General models)
.......................................................... | 2 SWITCHED OUTLETS |
(Australia model) ................................. | 1 SWITCHED OUTLET |
Use these to connect the power cords from your components to this unit.
The power to the SWITCHED outlets is controlled by this unit’s POWER switch or the provided remote control transmitter’s POWER key. These outlets will supply power to any component whenever this unit is turned on.
The maximum power (total power consumption of components) that can be connected to the SWITCHED AC OUTLET(S) is 100 watts.
GND terminal (For turntable use)
Connecting the ground wire of the turntable to the GND terminal will normally minimize hum, but in some cases better results may be obtained with the ground wire disconnected. Use one of the two GND terminals on the rear of this unit for the connection.
Turntable
FM 75Ω |
| GND |
ANT UNBAL | or |
|
|
| |
GND |
|
|
AM | Loosen | Tighten |
ANT |
9