Yamaha RX-V390, RX-V490 AUTOMATIC PRESET TUNING, To store stations, To recall a preset station, When the automatic preset tuning is finished

AUTOMATIC PRESET TUNING

You can also make use of an automatic preset tuning function for FM stations only. By this function, this unit performs automatic tuning and stores FM stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as in the manual preset tuning method on page 18.

2

1 3

To store stations

1	FM/AM
		FM
2	MEMORY
	FM
	MEMORY	AUTO TUNING
	Press and hold for
	about 3 seconds.	Flashes.
3	DOWN TUNING UP

To tune to higher frequencies, press right side once. To tune to lower frequencies, press left side once.

*If the TUNING button is not pressed, in a while, the automatic preset tuning begins automatically toward higher frequencies.

The automatic preset tuning begins from the frequency currently displayed. Received stations are programmed to A1, A2 ... A8 sequentially.

*If more than 8 stations are received, they are also programmed to the preset station numbers on other pages (B, C, D and E) in that order.

If you want to store the first station received by the automatic preset tuning to a desired preset station number.

If, for example, you want to store the first received station to C5, select “C5” by using theA/B/C/D/E button and the preset station buttons after pressing the MEMORY button in step 2. Then press the TUNING button. The first received station is stored to C5, and next stations to C6, C7 ... sequentially.

If stations are stored up to E8, the automatic preset tuning is finished automatically.

When the automatic preset tuning is finished

The display shows the frequency of the last preset station. Check the contents and the number of preset stations by following the procedure of the section “To recall a preset station” on page 18.

To recall a preset station

Simply follow the procedure of the section “To recall a preset station” on page 18.

Notes

●You can replace a preset station by another FM or AM station manually by simply following the procedure of the section “To store stations” on page 18.

●If the number of received stations is not enough to be stored up o E8, the search is finished automatically after searching through all frequencies.

●With this function, only FM stations with sufficient signal strength are stored automatically. If the station you want to program is weak in signal strength, tune to it in monaural manually and program it by following the procedure of the section “To store stations” on page 18.

19