Yamaha RX-V430, RX-V530 ■IMPEDANCE SELECTOR switch, WARNING

SPEAKER SETUP

■IMPEDANCE SELECTOR switch

WARNING

Do not change setting of the IMPEDANCE SELECTOR switch when the power of this unit is on, this may damage the unit. If this unit fails to turn on when STANDBY/ON (or SYSTEM POWER) is pressed, the IMPEDANCE SELECTOR switch may not be fully slid to either position. If so, slide the switch all the way to either position when this unit is in the standby mode.

Select the switch position (left or right) according to the impedance of the speakers in your system. Be sure to move this switch only when this unit is in the standby mode.

									Switch	Speaker	Impedance level
							CENTER		position
								+
										Main	The impedance of each speaker must
		SPEAKERS									be 4 Ω or higher.
								–
									Left	Center	The impedance must be 6 Ω or
			–					–			higher.
			+					+		Rear	The impedance of each speaker must
R	MAIN	L			R	REAR		L			be 6 Ω or higher.
						(SURROUND)
			MAIN			: 8ΩMIN. /SPEAKER				Main	The impedance of each speaker must
			CENTER			: 8ΩMIN. /SPEAKER
			REAR			: 8ΩMIN. /SPEAKER
			MAIN			: 4ΩMIN. /SPEAKER					be 8 Ω or higher.
			CENTER			: 6ΩMIN. /SPEAKER
	SET BEFORE POWER ON		REAR			: 6ΩMIN. /SPEAKER
	IMPEDANCE SELECTOR								Right	Center	The impedance must be 8 Ω or
						(RX-V530 U.S.A. model)					higher.
										Rear	The impedance of each speaker must
	RX-V430										be 8 Ω or higher.
						IMPEDANCE SELECTOR
						SET BEFORE POWER ON
		MAIN		:	4ΩMIN. /SPEAKER		MAIN	:	8ΩMIN. /SPEAKER
		CENTER		:	6ΩMIN. /SPEAKER		CENTER	:	8ΩMIN. /SPEAKER
		REAR		:	6ΩMIN. /SPEAKER		REAR	:	8ΩMIN. /SPEAKER

12