English

How to Connect:

Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.

Caution

Do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. This could damage this unit and/or speakers.

For connecting to the MAIN SPEAKERS terminals

For connecting to the REAR and CENTER SPEAKERS terminals

Red: positive (+)

Black: negative (–)

2

1

3

➀Unscrew the knob.

➁Insert the bare wire. [Remove approx. 5mm (1/4”) insulation from

the speaker wires.]

➂Tighten the knob and secure the wire.

Red: positive (+)

Black: negative (–)

➀

➂

➁

➀Press the tab.

➁Insert the bare wire. [Remove approx. 5mm (1/4”) insulation from the speaker wires.]

➂Release the tab and secure the wire.

Banana Plug connections are also possible (except for Singapore model). Simply insert the Banana Plug connector into the corresponding terminal.

For Custom Installer For U.S.A. and Canada models of RX-V692 only
REMOTE CONTROL (IN, OUT) terminals

These terminals are used for custom installation system. When this unit is connected to the components for custom installation system, you can operate this unit with the system remote control.

Connect the REMOTE CONTROL IN terminal of this unit to the output terminal of the central controller for custom installation system.

By connecting the REMOTE CONTROL OUT terminal of this unit to the REMOTE CONTROL IN terminal of the other component, you can also operate it with the system remote control. In this way, up to 6 components can be connected in series.

UT DVD/LD TV/DBS

REMOTE CONTROL

ER SURROUND

IN OUT

ON SCREEN SELECTOR

BS VIDEO VIDEO

ER

VIDEO SIGNAL

13