17

EnglishB ASIC OPERATION
ADV ANCED OPERA
TION APPENDIX
INTRODUCTION PREPARATION

Speaker cables

1Remove approx. 10 mm (3/8”) of insulation
from each of the speaker cables.
2Twist the exposed wires of the cable together
to prevent short circuits.

Connecting to the MAIN SPEAKERS terminals

1Unscrew the knob.
2Insert one bare wire into the hole in the side of
each terminal.
3Tighten the knob to secure the wire.

Connecting to the REAR and CENTER SPEAKERS terminals

1Open the tab.
2Insert one bare wire into the hole of each
terminal.
3Return the tab to secure the wire.

Connecting to an external amplifier

The speaker connections described on page 16 are fine for most applications. If you wish to drive your existing amplifier, the
following terminals are available for connecting an external amplifier(s) to this unit.
Note
Output signals from these terminals are affected by the use of VOLUME, BASS, TREBLE and BALANCE.
CONNECTIONS
2
1
3
Red: positive (+)
Black: negative (–)
2
3
1
Red: positive (+)
Black: negative (–)
1MAIN OUTPUT terminals
These terminals are for the main channel line output.
Connect the input terminals of the external amplifier to
these terminals.
2CENTER OUTPUT terminals
These terminals are for the center channel line output.
Connect the input terminals of the external amplifier to
these terminals.
3REAR (SURROUND) OUTPUT terminals
These terminals are for the rear channel line output.
Connect the input terminals of the external amplifier to
these terminals.
Note
If an external amplifier is connected to the MAIN, CENTER or
REAR OUTPUT terminals, disconnect the corresponding
speakers (main, center or rear) from the SPEAKERS terminals.