TROUBLESHOOTING

Problem

Cause

Remedy

Refer to

 

 

 

page

 

 

 

 

No sound from the rear

“SOUND 1C REAR LR” or “SOUND 1D

Select LRG or SML.

41

center speaker.

REAR CT” on the set menu is set to NON.

 

 

 

 

 

 

 

The Dolby Digital EX or the DTS-ES

Press 6.1/5.1 on the remote control to switch the

–

 

decoder is not switched on.

decoder on.

 

 

 

 

 

A “humming” sound can

Incorrect cable connections.

Firmly connect the audio plugs. If the problem

–

be heard.

 

persists, the cables may be defective.

 

 

 

 

 

 

No connection from the turntable to the

Connect the grounding cord of your turntable to

–

 

GND terminal.

the GND terminal of this unit.

 

 

 

 

 

The volume level is low

The record is being played on a turntable

The turntable should be connected to this unit

–

while playing a record.

with an MC cartridge.

through an MC-head amplifier.

 

 

 

 

 

The volume level cannot

The component connected to the OUT

Turn on the power to the component.

–

be increased, or the

(REC) jacks of this unit is turned off.

 

 

sound is distorted.

 

 

 

 

 

 

 

The sound effect cannot

It is not possible to record the sound effect

 

–

be recorded.

with a recording component.

 

 

 

 

 

 

A source cannot be

There is no source component connected

Connect the source component to the DIGITAL

10 – 12

recorded by a digital

to the DIGITAL INPUT jacks of this unit.

INPUT jacks of this unit.

 

recording component

 

 

 

connected to the

 

 

 

DIGITAL OUTPUT jack of

 

 

 

this unit.

 

 

 

The sound field parameters and some other settings on the unit cannot be changed.

“OPTION 2 MEM. GUARD” in the set menu is set to ON.

Set “OPTION 2 MEM. GUARD” in the set menu

–

to OFF.

 

The unit does not

The internal microcomputer has been

operate properly.

frozen by an external electric shock (such

 

as lightning or excessive static electricity)

 

or by a power supply with low voltage.

Disconnect the AC power cord from the outlet

–

and then plug it in again after about 30 seconds.

 

“CHECK SP WIRES” appears on the front panel display.

The speaker cables are short circuited.

Make sure all speaker cables are connected

–

correctly.

 

There is noise interference from digital or high-frequency equipment, or this unit.

This unit is too close to the digital or high- frequency equipment.

Move this unit further away from such

–

equipment.

 

The unit suddenly turns The internal temperature has become too

into standby mode. high and the overheat protection circuitry has been activated.

Wait until the unit cools down and then turn it

–

back on.

 

62