59
Multi Mode
21. AC1VarCtl
(AC1 Variation Effect Control Depth)
This determines the degree to which the Assignable
Controller 1 controls the Variation Effect.
❏ Settings: –64~+63
nThis can be set only when Variation Connection (above)
is set to “INS.” When Variation Connection is set to
“SYS,” “***” appears in the display and the setting
cannot be changed.
nThe particular parameter that can be controlled with the
Assignable Controller 1 is fixed for each of the Variation
effects. Refer to the separate Data List for details.
nFor information on the AC1, refer to AC1 CC No (pages
66 and 92 ) in the Multi and Utility modes.
Part
(Settings for each Part)
The following is an explanation of the Part parameters
used to edit each Multi.
nRefer to the Function Tree chart (page 20) or the
Parameter Table (page 22).
Voice Selection (PAGE 1)
Part Mix (PAGES 2 to 5)
Part General (PAGES 6 to 9)
Part Tone (PAGES 10 to 14)
Part Controller (PAGES 15 to 21)
Part Effect (PAGES 22 to 24)
1. Voice Selection
You can assign a Voice to each Part. Use the [+] and [–]
buttons to select the Part, then select its Voice. The
display will vary as follows according to the Memory
selected.
nSpecify the particular Voice Memory by pressing the
appropriate Memory button: PRESET, USER or GM/XG.
nTo select a Drum Voice, simultaneously hold down the
[DRUM] button and press the appropriate Memory
button: [USER] or [GM/XG].
nThe Voice can be set by using the same method as with
Category Search (page 35).
nFor details about Categories, refer to the Category List on
page 71. For details about using Category Search, see
page 35.
●PRESET
❏Settings: PR001 ~ PR128
AC1VarCtl
+00
KEYELEMPART
OCTAVE
PAGE
21
StPiano1
PR001
KEYELEMPART
OCTAVE
PAGE
1
Common Effect/Voice Selection