73
Voice Mode
Element Oscillator/Mixer
(PAGES 1 to 6)
Element Pitch (PAGES 7 to 12)
Element Filter (PAGES 13 to 22)
Element Amplitude (PAGES 23 to 31)
Element LFO (PAGES 32 to 35)
The following is an explanation of the Element
parameters used to edit each Voice.
nThe Element settings whose Element Switch is set to
“off” can not be changed and “***” appears in the
display.
1. Element Sw (Element Switch)
This determines whether each Element sounds or not.
❏Settings: off, on
2. Wave Selection
Select the Wave. Each Element can be assigned a
different wave (sound).
❏Settings: 1 ~ 453
nWave numbers indicated with an asterisk (*) and Wave
names indicated with an “at” mark (@) have fixed
parameter values (depending on the sound range). For
these waves, Element editing is limited to the Wave
selection and Element Switch parameters. All other
parameters’ values are replaced by a series of asterisks in
the LCD, indicating that they cannot be set.
3. Level
Set the output level of each Element.
❏Settings: 0 ~ 255
4. Pan
Set the Stereo Pan position for each wave.
❏Settings: Scale, L63 (Left) ~ C (Center) ~ R63 (Right)
Scale: Set the amount by which the sound is panned
left and right according to the position of the note on
the keyboard.
nYou can also enter the settings below using the numeric
keypad.
0: Scale
1~63: L63~L01
64: C (Center)
65~127: R01~R63
5-1. NtLmt-L (Note Limit Low)
5-2. NtLmt-H (Note Limit High)
Set the lowest and highest notes of the keyboard range
for each Element. Each Element will only sound for
notes played within its specified range.
❏Settings: C-2~G8
nYou can set the lowest and highest notes in the range by
pressing notes on the keyboard while holding down the
[ENTER] button.
Element Sw
KEYELEMPART
OCTAVE
PAGE on
1 E 1
KEYELEMPART
OCTAVE
PAGE
PianoL@
KEYELEMPART
OCTAVE
PAGE W*001
2 E 1
Wave category
Wave Name
Wave Number
Level
KEYELEMPART
OCTAVE
PAGE 240
3 E 1
Pan
KEYELEMPART
OCTAVE
PAGE C
4 E 1
NtLmt-L
KEYELEMPART
OCTAVE
PAGE C-2
5 E 1
NtLmt-H
KEYELEMPART
OCTAVE
PAGE G8
5 E 1
Element Oscillator/Mixer