Yamaha Soavo-1 owner manual Connections To Your Amplifier, English, Standard connections

CONNECTIONS TO YOUR AMPLIFIER

This speaker system is capable of standard connections and bi-wired connections. Before making connections, make sure that the amplifier is switched off.

English

■CONNECTIONS

<Standard connections>

•Connect the screw-type terminals at the rear of the speakers to the speaker terminals of the amplifier with the speaker cable (sold separately).

•Connect the (+) terminals on the amplifier and the speakers using one side of the cable. Connect the (–) terminals on both components using the other side of the cable.

•Connect one speaker to the left (L) terminals of your amplifier, and another speaker to the right (R) terminals, making sure not to reverse the polarity (+, –). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass.

How to connect the cables:

1Loosen the knob.

2Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.

Speakers terminals of the amplifier

Amplifier

SPEAKERS

RL

A

+ – – +

B

3Insert the bare wire into the hole.

4Tighten the knob and secure the cables.

Test the firmness of the connection by pulling lightly on the cables at the terminal.

Notes

•Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both of them.

•Do not insert the insulation coating into the hole. The sound may not be produced.

Soavo-1 (R)		Soavo-1 (L)
Leave the jumper	Loosen	Tighten
cables in place

when connecting.

Jumper cable

Bare wire

Insulation coating

3En