Operation
3.Secure the clamp bracket to the transom using the bolts provided with the out- board (if packed). For details, consult
your Yamaha dealer.
EWM00650
WARNING
Avoid using bolts, nuts or washers other than those contained in the engine pack- aging. If used, they must be of at least the same quality of material and strength and must be tightened securely. After tighten- ing, test run the engine and check their tightness.
1
ZMU02014
1. Bolts
EMU30171
Breaking in engine
Your new engine requires a period of
ECM00800
CAUTION:
Failure to follow the
EMU27080
Procedure for
Run the engine under load (in gear with a propeller installed) as follows.
1.For the first hour of operation:
Run the engine at 2000 r/min or at ap- proximately half throttle.
2.For the second hour of operation:
Run the engine at 3000 r/min or at ap- proximately
3.For the next eight hours of operation: Avoid continuous operation at full throttle for more than five minutes at a time.
4.After the first 10 hours:
Operate the engine normally.
EMU27101
Preoperation checks
EWM00080
WARNING
If any item in the preoperation check is not working properly, have it inspected and repaired before operating the outboard motor. Otherwise an accident could occur.
ECM00120
CAUTION:
Do not start the engine out of water. Overheating and serious engine damage can occur.
EMU27110
Fuel
●Check to be sure you have plenty of fuel for your trip.
●Make sure there are no fuel leaks or gaso- line fumes.
●Check fuel line connections to be sure they are tight (if equipped Yamaha fuel tank or boat tank).
●Be sure the fuel tank is positioned on a se- cure, flat surface, and that the fuel line is not twisted or flattened, or likely to contact sharp objects (if equipped Yamaha fuel
tank or boat tank).
EMU27130
Controls
●Check throttle, shift, and steering for proper operation before starting the engine.
26