Maintenance
ECM00710
CAUTION:
Inspect the used oil after it has been drained. If the oil is milky, water is getting into the gear case which can cause gear damage. Consult a Yamaha dealer for repair of the lower unit seals.
NOTE:
For disposal of used oil consult your Yamaha dealer.
5.With the outboard motor in a vertical po- sition, and using a flexible or pressurized filling device, inject the gear oil into the gear oil drain screw hole.
Recommended gear oil: Hypoid gear oil SAE#90
Gear oil quantity:
F6MHD 150.0 cm³ (5.07 US oz) (5.29 Imp.oz)
F8MHD 150.0 cm³ (5.07 US oz) (5.29 Imp.oz)
T8PRD 370.0 cm³ (12.51 US oz) (13.05 Imp.oz)
T8PHD 370.0 cm³ (12.51 US oz) (13.05 Imp.oz)
T8EHD 370.0 cm³ (12.51 US oz) (13.05 Imp.oz)
ZMU02065
6.When the oil begins to flow out of the oil level plug hole, insert and tighten the oil level plug.
7.Insert and tighten the gear oil drain
screw.
EMU29302
Cleaning fuel tank
EWM00920
WARNING
Gasoline is highly flammable, and its vapors are flammable and explosive.
●If you have any question about properly doing this procedure, consult your Yamaha dealer.
●Keep away from sparks, cigarettes, flames, or other sources of ignition when cleaning the fuel tank.
●Remove the fuel tank from the boat be- fore cleaning it. Work only outdoors in an area with good ventilation.
●Wipe up any spilled fuel immediately.
●Reassemble the fuel tank carefully. Im- proper assembly can result in a fuel leak, which could result in a fire or ex- plosion hazard.
●Dispose of old gasoline according to lo- cal regulations.
1.Empty the fuel tank into an approved con- tainer.
2.Pour a small amount of suitable solvent into the tank. Install the cap and shake the tank. Drain the solvent completely.
3.Remove the screws holding the fuel joint assembly. Pull the assembly out of the tank.
62